Silencer holder for the gun cabinet
Condition: New
Material: Plastic
Color (Type A and B): Matte black
According to the manufacturer (e.g., Hausken), silencers should be stored upright to allow for better ventilation. With this holder, you can easily attach your silencer to the gun cabinet and store it upright. Any residual moisture in the silencer can "fall out" through the hole in the bottom and be absorbed, for example, by the JS-3D drying box located in the cabinet.
The neodymium magnet holder can be attached to the gun cabinet as desired. The foam rubber on the back protects the gun cabinet from scratches.
Load capacity of the holder (Type A / Type B): over 2kg!
For non-magnetic surfaces, the silencer holder with the appropriate diameter and special adhesive tape is an option.
Each holder is available in 2 different variants: with special adhesive tape or with strong neodymium magnets.
Type A
A 50mm holder is suitable, for example, for all silencers with a maximum diameter of 50mm.
A 60mm holder is suitable, for example, for all silencers with a maximum diameter of 60mm.
etc.
Each holder therefore has a slightly larger diameter. This way, each holder fits perfectly!
Type B
A 50mm holder is designed for silencers up to a maximum diameter of 50mm.
A 60mm holder is designed for silencers from 51mm to a maximum diameter of 60mm.
A 70mm holder is designed for silencers from 61mm to a maximum diameter of 70mm.
Also with this type, each holder has a slightly larger diameter - perfect fit!
Note: If you use a cover for the silencer and do not remove it, you would have to take the holder one/two size/s larger or check the diameter (silencer including cover).
Scope of delivery:
- One black holder for silencers with up to 70mm diameter - depending on the version, with neodymium magnets or special adhesive tape
Dimensions Type A:
The round holder is 11.5cm high.
The entire holder is 6x16cm (the rear back plate).
Dimensions Type B:
Each holder of this design has a height of approx. 12cm (front) and 16cm (back).
